Table of Contents
Advertisement
Restoring the Factory Default Settings
(Factory Reset)
Not only can you return all of the settings to the values in effect
when the RC-5 was shipped from the factory, you can also specify
the items to be reset.
* When you execute "Factory Reset, " the settings you made will
be lost. In advance, back up important data to your computer.
1 .
Press the [SETUP] button.
The SETUP screen appears.
SETUP
J
GENERAL
2 .
Turn the [MEMORY/LOOP LEVEL] knob to select
"F.RESET," and press the [MEMORY/LOOP LEVEL]
knob.
F .RESET
J
MEMORY
3 .
Turn the [MEMORY/LOOP LEVEL] knob to specify the
settings that will be returned to their factory-set state,
and press the [MEMORY/LOOP LEVEL] knob.
Value
Explanation
MEMORY
Memory 1–99
SYSTEM
System settings
MEM+SYS
Memory 1–99 and system settings
A confirmation message "ARE YOU OK?" appears.
* If you decide not to execute the factory reset, select "CANCEL"
and press the [MEMORY/LOOP LEVEL] knob.
4 .
Turn the [MEMORY/LOOP LEVEL] knob to select "OK,"
and press the [MEMORY/LOOP LEVEL] knob.
The factory reset is executed.
* Do not turn off the power while the "EXECUTING... " message is
shown.
Once the factory reset is complete, you are returned to the Play
screen.
Changing the Battery
9 V Battery
1 .
Hold down the pedal and loosen the thumbscrew
then open the pedal
* The pedal can be opened without detaching the thumbscrew
completely.
2 .
Remove the old battery from the battery housing
and remove the battery snap
3 .
Connect the battery snap to the new battery, and
place the battery inside the battery housing.
* Be sure to carefully observe the battery's polarity (+ versus -).
4 .
Slip the coil spring
the back of the pedal, and then close the pedal.
* Carefully avoid getting the battery snap cord
pedal, coil spring, and battery housing.
5 .
Insert the thumbscrew into the guide bush hole
and tighten it securely.
Appendix
upward.
connected to it.
onto the spring base
caught in the
,
,
on
21
Hide quick links:
Advertisement
Table of Contents
