Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 575XP AutoTune EPA I Operator's Manual

Symbols on the mac hine:
W ARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to
the operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any object
must be avoided.
Tip contact may cause the guide bar to
move suddenly upward and backward (so-
called kickback), which may cause serious
injury.
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
2 – English
KEY T O SYMBOLS
Symbols in the operator' s manual:
Switch off the engine by moving the
stop switch to the STOP position before
carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake should be activated
when starting.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.