Key To Symbols; Symbols On The Machine - Husqvarna 365 SPECIAL Operator's Manual

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
Tip contact may cause the guide bar to
move suddenly upward and backward (so-
called kickback), which may cause serious
injury.
Recommended cutting
equipment in this example:
- Bar length 18 inches
- Max tooth count for the bar
nose sprocket is 11T
- Chain type Husqvarna H42
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Decompression valve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
2 – English

KEY TO SYMBOLS

Adjustment of the oil pump
Refuelling.
Chain oil fill.
Chain brake, activated (right)
Chain brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
The engine exhaust from this product
contains chemicals known to the State
XX
XX
of California to cause cancer, birth
defects or other reproductive harm.