Cleaning Bare Floors - Hoover SteamVac Owner's Manual

Hide thumbs Also See for SteamVac:
Table of Contents

Advertisement

Available languages

Available languages

CleaninG bare floors

how to attach bare floor attachment
(available on select models only)
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner.
To prevent possible leaking, remove Clean Water
Solution Tank and Dirty Water Tank before positioning
bare floor attachment.
Refer to Fig. 2.4 to remove Clean Water Solution
Tank. Set tank aside (do not set tank on furniture).
Refer to Fig. 2.8 to remove Dirty Water Tank.
With handle in upright position, tilt cleaner back so
that handle rests on the floor.
3.3 With foam strip (A) (located under the netting) in
position as shown, place attachment on front of
nozzle (B).
Make sure arrow on end of attachment points in the
direction as shown.
3.4 Push attachment against nozzle while rotating
attachment downward until both ends snap into
place.
to Clean bare floors
IMPORTANT
Read Before you begin cleaning. Do not use the
SteamVac
®
cleaner on hardwood floors.
Fill Clean Water Solution Tank with HOOVER
detergent (available at additional cost if not included
with your model) according to instruction on page 8.
Do not use any type of wax with your SteamVac
cleaner.
Dry hands and plug cleaner into a properly
grounded outlet.
Step on handle release pedal and lower handle to
operating position; turn cleaner ON.
To release detergent, press trigger. Slowly move
cleaner forward and backward over area to be
cleaned.
To pick up dirty solution, release trigger and slowly
move cleaner over area where solution has just been
dispersed. Use both forward and reverse strokes.
Remove attachment from nozzle and rinse in clean
water. Do not remove plastic screen or foam from
attachment.
Actual model may vary from images shown.
3.3
A
!
b
(Note: Some force may be required to rotate and
snap attachment into place.) Return carpet cleaner to
upright position. Lower handle and replace Dirty
Water Tank.
Raise handle to upright position and reposition Clean
Water Solution Tank.
DO NOT USE THIS EXTRACTOR ON HARD
FLOORS UNLESS YOU HAVE THE PROPER
HARD FLOOR ATTACHMENT. USING THIS
MACHINE ON HARD FLOORS WITHOUT
PROPER ATTACHMENT MAY SCRATCH OR
DAMAGE YOUR FLOOR.
DO NOT USE THIS EXTRACTOR ON HARD
FLOORS UNLESS YOU HAVE THE PROPER
HARD FLOOR ATTACHMENT. USING THIS
MACHINE ON HARD FLOORS WITHOUT
PROPER ATTACHMENT MAY SCRATCH OR
®
DAMAGE YOUR FLOOR.
®
12
3.4
CAUTION
!
CAUTION
!
!
!

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents