Cleaning Bare Floors; Us Ing The S Tair/Uphols Tery - Hoover BRUSH N WASH Instructions Manual

Cleaning bare floors

How to attach bare floor
attachment
(available at addi-
tional cost if not included with your
Unplug the cleaner from electrical
cleaner)
socket.
To prevent possible leaking, remove
clean solution tank and recovery tank
before positioning bare attachment.
Refer to Fig. 23 to remove clean solution
tank. Set tank aside (do not set tank on
furniture).
Refer to Fig. 30 to remove recovery tank.
A
37
B
With handle in upright position, tilt
37
cleaner back so that handle rests
on the floor.
With foam strip (A) (located under the
netting) in position as shown, place
attachment on front of nozzle (B).
Make sure arrow on end of attachment
points in the direction as shown.
Using the stair/
upholstery nozzle
Unplug the cleaner from electrical
How to attach hose
socket.
39
A
To prevent possible leaking,
39
remove clean solution tank by
pressing down on tank handle (A) and
pulling forward; set tank aside (do not
set tank on furniture).
Remove hose from storage rack.
38
Push attachment against nozzle while
38
rotating attachment downward until
(Note: Some force may be required to
both ends snap into place.
rotate and snap attachment into place.)
Return cleaner to upright position.
Lower handle and replace recovery
properly seated in place. Rotate latch-
tank. Press down to ensure that it is
es (one on each side of tank) inward
to lock tank in place.
Raise handle to upright position and
reposition clean solution tank.
Read Before you begin cleaning
To clean floor
instructions on page 9.
Do not use the cleaner on hardwood
floors.
Fill clean solution tank with HOOVER
Bare Floor Cleaner (available at additional
cost if not included with your model)
according to instructions on pages 7
and 8.
40
B
Step on handle release pedal (B)
40
and lower cleaner handle until it
rests on the floor.
Unlatch back part of recovery tank and
remove lid.
Do not use any type of wax with your
Brush ʻNʼ Wash cleaner.
Move speed selector to the LO or Hl
position for scrubbing or OFF if
scrubbing is not desired.
Dry hands and plug cleaner into an
earthed electrical socket.
Step on handle release pedal and lower
handle to operating position; turn clean-
er ON.
To release solution, press trigger. Slowly
move cleaner forward and backward
over area to be cleaned.
To pick up dirty solution, release trigger
and slowly move cleaner over area
where solution has just been dispersed.
Use both forward and reverse strokes.
Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see
"Automatic shut-off", page 6).
When finished cleaning, follow "After
cleaning" instructions on page 10.
rinse in clear water. Do not remove
Remove attachment from nozzle and
plastic screen or foam from attach-
ment.
41
Remove recovery tank front panel
41
(C) by sliding it straight up.
C
11