Page 1
à commencer le nettoyage! ® Hoover SteamVac™ cleans carpet fibers by applying, scrubbing and removing hot tap water and cleaning solution. Le SteamVac de Hoover nettoie en profondeur les fibres de tapis en appliquant et en aspirant de l’eau chaude du robinet et une solution nettoyante et grâce à son action de frottage.
Page 2
HOOVER SALES & SERVICE CENTERS CENTRES DE VENTE ET DE SERVICE HOOVER MICHIGAN ALABAMA COLORADO The Maples Shpg. Ctr. 10244 W. National Ave. NORTH CAROLINA Pinebrook Shpg. Ctr. Academy Pl. Shpg. Ctr. West Allis, WI 53227 1010 Murfreesboro Rd. Evergreen Plaza Shpg. Ctr.
HANDLING. water, take it to a Hoover Sales and (Fig. 2). Whenever the adapter is used, it Service Center or Authorized must be held in place by a metal screw.
Operate carpet cleaner only at voltage specified on data plate on back of cleaner. Plug carpet cleaner into a properly grounded outlet. Your HOOVER SteamVac™ Spot™ carpet cleaner is fully assembled and ready to begin cleaning! Unfold handle How to fold handle...
Pour detergent into tank to detergent fill line (E) (Fig. 6). Fill tank completely with hot tap water. NOTE: For best results, use only Hoover detergents. They are specifically formulated for use with your SteamVac™ Spot™ carpet cleaner. Replace cap. Be sure the valve (D) is in the cap ring (C) before screwing the cap back on the tank (Fig.
Empty the recovery tank Unplug carpet cleaner from electrical outlet. An automatic shut-off device prevents the carpet cleaner from picking up more dirty water than it can hold in the recovery tank. You will know the tank needs to be emptied -- •...
Transporting Your carpet cleaner may be transported easily by the convenient carrying handle (A) (Fig. 13). Using the hose and tool Using the hose Place handle in upright, storage position. Press on the tab (A) to remove the hose wand (B) from the floor nozzle (C) (Fig.
Wait ten minutes. Blot with white cloth or paper towel and check for color transfer. Pretreat spots, stains and high traffic areas with HOOVER Spot and Stain Spray (Fig. 20). Spray spot or area with Spot and Stain Spray. Then proceed with the next cleaning steps.
Spray spot or area with Spot and Stain Spray. Then proceed with the next cleaning steps. Fill solution tank with hot tap water and proper amount of HOOVER deter- gent (see page 5)(Fig. 27). Use only HOOVER brand detergents in your carpet cleaner. Other brands may damage the carpet cleaner.
Routine care for your carpet cleaner Clean the nozzle Unplug carpet cleaner from electrical outlet. Wipe debris off nozzle and front of cleaner with a damp cloth (Fig. 31). Clean the brushes Unplug carpet cleaner from electrical outlet. Remove solution and recovery tanks to prevent possible leaks. Tilt cleaner back so handle rests on the floor (Fig.
Calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) Do not send your cleaner to Hoover in North Canton, Ohio for service; this will only result in delay. If further assistance is needed, contact the Hoover Consumer Response Center, Phone: 330-499-9499.