Last Function Memory; Resetting The Microprocessor - Denon DNP-720AE Owner's Manual

ENGliSh
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
Button only on the main unit
Button only on the remote control
<SOURCE>
[ENTER]
32
Using the cursor buttons
1
Display the screen for inputting characters.
BUTTON
<BUTTON>
[BUTTON]
2
Use o p to set the cursor to the character you want
to change.
uio p
3
Use ui to change the character.
• The types of characters that can be input are as shown below.
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
G Upper case charactersH
<1/3 ENTER>
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH ! " # $ % & ' ( ) z + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | }
GNumbersH 0123456789 (Space)
• The input character type can be switched by pressing
while the display name is being changed.
[CLEAR]
• Press to delete the character.
[9]
• Press to insert a space.
4
Repeat steps 2 and 3 to change the name then press
[9]
[ENTER] or
[MODE]
uio p
[CLEAR]
[MODE]
< / ENTER> to register it.
1 3

Last function memory

This stores the settings as they were immediately before going into
the standby mode.
When the power is turned back on, the settings are restored to as
they were immediately before going into the standby mode.

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to their
default values.
1
Pull the power cord out of the power outlet.
2
Plug the power cord into a power outlet while pressing
˜
<SOURCE> < / ENTER>
and 1 3
3
When the power indicator lights green, release the
buttons.
"Initialized" appears in the display.
If "Initialized" does not display in step 3, start over from step 1.
Other functions
simultaneously.