Installing And Removing A Hot-Swap Hard Drive; Installing A Sas Or Sata Hot-Swap Hard Disk Drive; Figure 33. Installing The Large Air Baffle - Intel SERVER SYSTEM SR2500AL User Manual

3. Install the server system cover. For instructions, see
Cover".
4. Plug all peripheral devices and the AC power cable(s) into the server.

Installing and Removing a Hot-swap Hard Drive

Up to six hot-swap SAS or SATA drives can be installed.
Cautions: If you install less than six drives or devices, empty drive bays must be occupied by
carriers with baffles to maintain proper system cooling.
To avoid possible damage to your server system, do not use older style drive carriers.
Note: The server system does not support all hard drives. See
an Internet link to a list of supported hardware.

Installing a SAS or SATA Hot-swap Hard Disk Drive

1. Remove the front bezel if it is installed. For instructions, see
Bezel".
2. Open the latch at the front of the hard drive carrier. See letter "A" in the figure
below.
44

Figure 33. Installing the Large Air Baffle

"Installing the Server System
"Server System References"
"Removing the Front
Intel® Server System SR2500AL User's Guide
TP02134
for