Table of Contents
Advertisement
System Setup
7. Press the
button to select C WIDTH.
8. Use the
and
buttons to cycle through the C Width
options.
The C Width settings appear as follows as you scroll through
them:
STEP 0 > STEP 1 > STEP 2 > STEP 3 > STEP 4- >
STEP 5 > STEP 6 > STEP 7
You can scroll in either direction using the
Depending on how the Center Width control is set, you may
adjust the apparent placement of the center channel image so
that it is heard only from the center speaker, so that it is blended
into the left and right speakers as a phantom image, or that it is
blended among the front left, center and right speakers in
varying amounts. As with the other Pro Logic II controls, the use
of this setting and the degree to which it is used is a matter of
personal preference.
9. Press the
button to select RETURN TO MAIN MENU
10.Press the MENU button to return to the Main Menu, or
press the MENU button twice to exit.
MULTI–ZONE – Setup and Selection
This menu controls the setting for your second zone (zone 2) and
the output from the ZONE OUT jacks on the rear of the FAP T1.
This function can be accessed in two ways. You can press the
MULTI (T/V) button on the remote control, or you can access this
feature through the MAIN MENU. The Multi-zone menu is shown
below.
NOTE:The following selected menus appear on the FAP T1
Display and the OSD (On Screen Display)
Figure 6
To adjust the Multi-zone settings:
1. Press the MENU button to enter the Main Menu.
The Main Menu appears and the cursor should be pointing to
INPUT CONFIG.
24
2. Press the
3. Press
The MULTI–ZONE menu appears the cursor should be pointing
to MULTI-ZONE.
4. Use the
MULTI–ZONE feature ON or OFF.
If ON is selected, the blue LED below the word ZONE on the
and
buttons.
front panel will illuminate indicating activation of the second
stereo zone.
5. Press the
6. Use the
will be sent through the ZONE OUT outputs to the second
zone (Zone 2).
The Source choices appear as follows as you scroll through
them:
DVD > VIDE01 > VIDE02 > VIDE03 > VCR > TUNER
> CD > TAPE > AUX1 > AUX 2
You can scroll in either direction using the
7. Press the
8. Use the
MULTI–ZONE mute function is ON or OFF.
9. Press the
10.Use the
volume level of the signal being sent to the second zone
(Zone 2).
The range available is from -80dB to 10dB. Use caution as you
can set a very high volume level and not be aware of it because
of the distance between you and the second zone.
11.Press the
12.Press the
Main Menu, or press the MENU button twice to exit.
Direct Operation
In addition to entering settings into the FAP T1 using the Menu
System, as described, many of the controls may be changed
directly at any time using the remote control or front panel buttons.
To change one of these settings (for example, Channel Trim),
simply press the appropriate button on the remote or front panel
and use the navigation buttons as required to change the settings.
button until MULTI–ZONE is selected.
(Select) to enter the MULTI–ZONE menu.
and
buttons to select whether you want the
button to select INPUT.
and
buttons to select which source signal
button to select MUTE.
and
buttons to select whether the
button to select VOLUME.
and
buttons to increase or decrease the
button to select RETURN TO MAIN MENU.
(Select) or MENU button to return to the
and
buttons.
Hide quick links:
Advertisement
Table of Contents
