Sherwood R-945MKII Operating Instructions Manual page 21

Presetting radio stations
You can store up to 30 preferred stations in the
memory.
Tune in the desired station with auto or
3
manual tuning, etc.
Press the MEMORY/ENTER button.
4
MEMO / ENTER
"MEMORY" is flickering for 5 seconds.
Enter a preset number (1~30).
5
Examples)
3
For "3" : or
within 2 seconds
1 5
For "15" :
or
The station has now been stored in the memory
A stored frequency is erased from the memory by
storing another frequency in its place.
If "MEMORY" goes off, press the MEMORY/ENTER
button again to enter a preset number.
Repeat the above steps 3 to 5 to memorize other
stations.
Tuning to preset stations
Press the desired preset number.
2
Example)
3
For "3" :
or
within 2 seconds
1 5
For "15" :
or
When pressing the numeric buttons on the front
panel without selecting the TUNER, the tuner will be
selected automatically and the preset station will be
tuned in.
within 2 seconds
within 2 seconds
21
Listening to FM stereo broadcasts
While listening to FM broadcasts.
FM MODE
Each time this button is pressed, the FM mode
changes as follows;
Stereo mode : "ST" lights up
Mono mode : "ST" goes off
When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound
Scanning preset stations in sequence
1
The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
At the desired station, press this button
2
again to stop scanning.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned off,
are memorized.
• INPUT SELECTOR settings
• VCR 1 REC SELECTOR settings
• Surround mode settings
• Preset stations
• Video labels, etc.
Note:If the electricity fails or the AC input cord is
disconnected for about 2 weeks, they are all cleared.
So you should memorize them again.