Sherwood R-945MKII Operating Instructions Manual page 18

Cancel the test tone function.
13
In Dolby Digital(AC-3), Dolby Pro Logic
mode, adjusting delay times of the speakers
When the distances from the prime listening
position to front left, center, front right and rear (left
and right) speakers are same, the basic settings are
as follows according to either the Dolby
Digital(AC-3) or the Dolby Pro Logic mode;
In the Dolby Digital(AC-3) mode.
Center delay time : 0 ms, Rear delay time : 0 ms
In the Dolby Pro Logic mode.
Rear delay time : 15 ms
If the center or the rear speaker(s) is(are) not at the
same distance from the prime listening position as
the front speakers, increase or decrease the center
delay time by 1 ms for every about 30 cm(1 foot) it
is closer or farther away and increase or decrease the
rear delay time by 5 ms for every about 1~1.5 m
(3~5 feet) it is closer or farther away.
Check the delay time to be
14
adjusted.
• The delay time will be displayed for 5 seconds.
• Only in the Dolby Digital(AC-3) mode, the center
delay time can be adjusted and the corresponding
delay time is flickering.
Adjust the delay time.
15
Each time this button is pressed, the delay time
changes in regular intervals.
If the delay time disappears, start from the step 14 again.
Memorize the delay time.
16
In Dolby Pro Logic mode, the rear delay time can be
memorized without pressing the DELAY TIME button.
In Dolby Digital(AC-3) mode, repeat the
17
above steps 15 and 16 to adjust the rear
delay time.
In THEATER, HALL, STADIUM or
CHURCH Mode
Adjust the volume level of the rear speakers
11
relative to that of the front speakers.
- REAR LEVEL +
or
18