HoMedics Circulator Instruction Manual page 16

IB-CB200GB-1213-02_Layout 1 16/12/2013 12:02 Page 16
CONNECT WITH THE SUPPLIED AC/DC POWER ADAPTER
INSTALLING BATTERIES FOR MAIN UNIT
If you want to use the Circulator with battery power instead of the supplied main adapter, the battery
compartment is located on the underside of the unit.
Remove the battery cover from the unit by removing the screw with a screwdriver. Insert the new 4 pieces
1.5V size AA batteries with the + and -marks correctly aligned.
INSTALLING BATTERIES FOR REMOTE CONTROL
Remove the battery cover from the unit by removing the screw with the screwdriver. Insert the new 2 pieces
1.5V size AAA batteries with the + and -marks correctly aligned.
Fig. 8
The transmitter of the remote control is at the top of it in black colour (Fig. 10), for
using the remote control, please remember to point the transmitter to the
receiver of the main unit, which is located at between the gel pad jack of the main
unit. (Fig. 11).
Note on batteries:
Do not mix different types of batteries or an old battery with a new one. To prevent the risk of leakage or
explosions, never recharge the batteries, apply heat or take them apart.
When not using batteries, remove them to prevent battery drain. If liquid leaks from the batteries, throw them
away. See page 4 for correct disposal. Thoroughly clean the battery compartment with a dry cloth.
Fig. 8
Fig. 9
16
Plug the DC plug of the power supply into the
socket on the side of the Circulator (See Fig 8). Plug in
power adapter to a suitable wall socket. (Make sure
that the input voltage of the wall socket is suitable for
the supplied adapter).
Fig. 10
Fig. 11