Additional Accessories - HoMedics Circulator Instruction Manual

IB-CB200GB-1213-02_Layout 1 16/12/2013 12:02 Page 15
For Body
USING THE GEL PADS
Wash and dry skin before use. Connect the output wire to the gel pads. Connect the other end of the output
wire to the output jack on the Circulator. Remove the protective film from the adhesive pads. Attach the gel
pads to the skin. Press the on/off button to turn on the unit and adjust the stimulating output intensity to the
desired level. (The display will show the mode and level that you selected and start to count down).
Fig. 5
1. Plug in the 2 cables into the cable jack on the unit (see Fig. 5).
2. Connect pin of the cable to the gel pad properly (see Fig.6).
3. Remove the protective film on the gel pad, and attached the 4 gel pads to
the area of the body you wish to treat in accordance with warnings.
4. Repeat operation as in foot instructions, adjust the intensity using for body.
5. Gently increase intensity setting by pushing the button of "Body + ". Or
decrease intensity setting by pushing the button of "Body - ". The LCD will also show the level which you
have selected (see Fig. 7).
6. To terminate the massage period, user can turn off the unit anytime by pressing the on/off Button.
If you want to use with 2 gel pads only, then you must connect 1 gel pad to jack A and 1 gel pad to Jack B.

ADDITIONAL ACCESSORIES

Replacement gel pads
For information on how to buy replacement gel pads, please visit www.homedics.co.uk
Fig. 6
Care of your gel pads
Never stick two adhesive pads to each other. Keep the adhesive gel pads
clean, never expose them to high temperature or direct sunshine. If the
electrode gel pads are insufficiently adhesive or dirty, wipe with a wet cloth
or change for new ones, replacement parts will be available directly from
Homedics or your distributor.
Do not clean the electrode gel pads with any chemical.
ALWAYS try and protect the gel pads store the gel pads on the gel pad
protector when not in use, as in the illustration.
15
Fig. 7