Page 2
Unauthorized sub- For products intended to operate from battery power, or other stitutions may result in fire, electric shock or other hazards. sources, refer to the operating instructions. TSS-SUB4000...
22251_Inf_TSS_SUB_400O_eng 04/02/05 11:08 Side 3 TSS-SUB4000 O ’ WNER UIDE Table of Contents Important Safety Precautions Unpacking the Subwoofer Placement Controls and Connections Connections Operation Room Adaptive Bass Optimization System ™ (R.A.B.O.S. ™ Contents of the R.A.B.O.S.Test CD The R.A.B.O.S. Sound-Level Meter (RSLM)
™ , along with a rigid, well-braced enclosure, combine to deliver uncompromised bass performance in any stereo or mul- tichannel home theater. In addition, the TSS-SUB4000’s com- pact enclosure allows for easy integration into any home envi- ronment. Unpacking the Subwoofer If you suspect damage from transit, report it immediately to your dealer.
LFE output as described to the left). connect the LFE output on your receiver/processor to either the In that case, left or right input on the subwoofer. it is recommended that you use a Y connector (not included) to maximize performance. TSS-SUB4000...
However, overall balance must be maintained or the music will not sound natural.An experienced listener will set the volume of the sub- woofer so its impact on bass response is always there but never obtrusive. TSS-SUB4000...
Page 8
Using the Width Selector, you will then determine the appropri- ate equalizer settings.The “Key”is used to adjust the paramet- ric equalizer built into the TSS-SUB4000.After adjustment, the For best results, it is recommended that all major furnishings test sequence is repeated to confirm your settings.
THE R.A.B.O.S. SOUND-LEVEL METER (RSLM) Do not attempt measurements when this light is on. The RSLM is a battery-operated, handheld, acoustic measure- ment device specifically designed for Infinity R.A.B.O.S. On the RSLM Placement face of the instrument is a light-emitting diode (LED) bar graph that indicates relative sound level.There are also indicators for...
RSLM to give a stable reading. To get accurate measurements, it is necessary to play the TSS-SUB4000 quite loud.The 0dB indication is about 94dB. At this level, frequencies below 100Hz can cause doors, win- dows, furnishings and other objects in the room to vibrate.This frequently results in clearly audible buzzes and/or rattles that come and go as each test tone plays.
Page 11
See Figure 9. Figure 11. Test example with dots connected Figure 9. Indicating an under-range test When finished, press Skip ›› I to advance to the next test. Repeat the process described above for Tracks 5 through 26. TSS-SUB4000...
Bandwidth: Defines the range of frequencies over which the quency band of 1/4 of an octave; 1/8 of an octave above and equalizer will have an effect. On the TSS-SUB4000, this adjust- 1/8 of an octave below the center frequency.
Selector over the response peak, as shown in Figure 14. Be sure to align the horizontal lines of the Width Selector with those of the Measurement Template. Figure 15. Selector adjusted for the “best fit” TSS-SUB4000...
Remember, when looking for a match, look at the descriptive characteristics, not any specific frequency or level. Each of these examples can occur at any frequency, bandwidth and level. It is unlikely that your test results will be exactly as depicted in these examples. TSS-SUB4000...
Page 15
RSLM vertically. Dips can be oriented in any axis.The position that restores the level to about that of the adjacent test points is your new test position. TSS-SUB4000...
Page 16
The position that restores the level to about that of the adjacent this example, the frequency is 40Hz and the best-fit width is test points is your new test position. 10%. Fill in the Width and Frequency fields provided on the template. TSS-SUB4000...
RSLM. Of course, you may fine-tune the sary, indicated by the results of your R.A.B.O.S.Test. subwoofer gain control to your listening preference. TSS-SUB4000 R.A.B.O.S. Controls This concludes the R.A.B.O.S. process. It is recommended that you remove the battery from the RSLM. Store the Test CD, Width Selector,Adjustment Key and the RSLM together.
If a problem occurs, make sure that all connections are proper- ly made and are clean. In the event that your TSS-SUB4000 subwoofer ever needs service, contact your local Infinity dealer or Infinity directly at 1.516.674.4INF (USA only) or...
Page 20
22251_Inf_TSS_SUB_400O_eng 04/02/05 11:09 Side 20 TSS-SUB4000...
Page 21
22251_Inf_TSS_SUB_400O_eng 04/02/05 11:09 Side 21 TSS-SUB4000...
(17-1/2" x 17-1/4" x 11-1/8") Weight 21.8kg (48 lb) Infinity continually strives to update and improve existing products, as well as create new ones. The specifications and construction details in this and related Infinity publications are therefore subject to change without notice.
Page 23
22251_Inf_TSS_SUB_400O_eng 04/02/05 11:09 Side 23 OTES...
Page 24
* Trademark of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity and MMD are registered trademarks, and Metal Matrix Diaphragm, Room Adaptive Bass Optimization System and R.A.B.O.S. are trademarks, of Harman International Industries, Incorporated. Part No. 406-000-05133 01/05...