Table of Contents
Advertisement
2
INSTALLING THE FAUCET
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Make sure to use rubber O-ring
to ensure proper seal.
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
D
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing.
Ensure that the black O-ring is
properly seated in the base of the
dispenser head (the groove on the
underside of the dispenser).
Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
Place hex nut onto the threaded stud.
Ensure faucet head is at desired angle.
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure faucet.
7
Advertisement
Table of Contents
