Quick Start; Input; Stompbox Encoder; Amp Encoder - Peavey Vypyr 30 Player's Handbook

Quick Start

5
1 2 3 4
0 15
13 14

0 - Input

If you are having trouble figuring out what this is then please put the amp back in the box and get some
drumsticks.*

1 - Stompbox Encoder

Not available on the VYPYR 15
Turn this knob to select your desired pre-amplifier effect if any. Just think, 11 pedals you'll NEVER
have to buy! Press the encoder momentarily to enter Edit mode (15).

2 - Amp Encoder

Turn this knob to select your amp model. If the LIGHT IS RED you are on the HIGH GAIN CHAN-
NEL. If the LIGHT IS GREEN you are on the LOW GAIN SETTING. Press and HOLD FOR 2 SEC-
ONDS to enter tuner mode. The LEDs around the Amp encoder will identify which note you are tuning
(or the closest note). At the same time the LEDs around Effects encoder (3) will indicate whether the
note is sharp or flat. If the green LED is to the RIGHT of the 12 o'clock position you are SHARP (tune
down). If the green LED is to the LEFT of the 12 o'clock position you are FLAT (tune up). When ALL
of the LEDs AROUND THE EFFECTS encoder come on, you are IN TUNE!
3 - Effects Encoder
Turn this knob to select any "rack" effect. These are effects you might find connected to the effects
loop of an amplifier. Press the encoder momentarily to enter Edit mode (15).
4 - Pre Gain
Turn this knob to crank up the gain and dial in the amount of distortion you want out of the amplifier. In
Edit mode, this knob controls parameter one of either the selected Stompbox or Effect (15).
*No drummers were harmed in the making of this manual.