Table of Contents
Advertisement
By doing this, any water remaining in the machine is removed, avoiding
ice forming and consequently damage to the appliance.
When you use the machine again, make sure that the ambient temper-
ature is above 0°C.
Important
!
Every time you drain the water through the emergency emptying hose
you must pour 2 litres of water into the main wash compartment of the
detergent drawer and then run the DRAIN programme. This will activate
the ECO valve allowing a total use of the detergent in the next wash.
Something not working?
If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to the mod-
ern technology of new washing machines that
use less water than traditional machines.
Troubleshooting
If a problem arises, you can try to solve it your-
self following the instructions below.
If you call out an engineer when one of the following problems aris-
es, or to repair a fault due to incorrect use, the call-out will be
charged even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
-
E10: problem with the water supply (phase light EXTRA RINSE is on)
-
E20: problem with water draining (phase light RINSES is on)
-
E40: door open (phase light WASH is on)
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, con-
tact your local AEG Service Force Centre.
37
Hide quick links:
Advertisement
Table of Contents
