AEG LAVAMAT 12710 TURBO ELECTRONIC Instruction Booklet page 39

Problem
There is water on the floor
The machine vibrates or is
noisy
The door will not open
Possible cause
Too much detergent has
been used.
An unsuitable detergent
has been used that
creates too much foam.
One of the connectors on
the water inlet hose is
leaking.
The drain pump has not
been properly screwed on
after cleaning.
The cap on the emergency
emptying hose has not been emergency emptying hose
replaced after cleaning the
pump.
The transit bolts have
not been removed.
The feet have not been
adjusted.
There is little laundry in
the drum.
The programme is still
running and the drum
is turning.
The water level is above the
bottom edge of the door.
The machine is heating the Wait until the end of the
water or drying the
clothes.
Something not working?
Solution
Measure detergent
according to the
manufacturer's instructions.
Use a suitable washing
machine detergent.
Check that the hose is
firmly screwed on at both
ends.
Fully screw the pump into
place.
Replace the cap on the
after cleaning the pump.
Check that the machine
has been unpacked as
described in the Installation
section.
Carefully level the machine.
Correct operation of the
machine is not affected.
Wait until the end of the
programme before opening
the door.
Before opening the door,
the water must be emptied
out.
heating or drying phase.
39