Others; Relay Recording; A-B Recording - Toshiba RD-XS52SU Owner's Manual

Recording

Others

Relay Recording

HDD
This function automatically diverts a recording to the
HDD if a DVD-RAM disc is near capacity.
When the remaining time of the DVD-RAM disc has
reached about 10 minutes, the recorder starts
recording the same content on the HDD as well as
DVD-RAM. The chapter marks are automatically made
at the start and end points of the overlapped recording
portion. You can delete the unnecessary overlapped
portion afterwards by referring to the chapter marks.
Recording end
DVD-RAM disc
10min.
Recording start
To engage the Relay Recording function, set "Relay
recording" to "On" ( page 163).
Notes
• When the capacity of the HDD is not sufficient, the
operation is canceled.
• While recording the overlapped portion, you cannot pause
the recording.
• While recording the overlapped portion, you cannot play a
recorded title on the same disc.
• When another programmed recording is set just after the
relay recording, the relay recording stops about 2 minutes
before the next programmed recording starts.
A–B Recording
HDD
This function records one program at the highest
possible rate onto a double sided DVD-RAM disc
(9.4GB) or 2 single sided DVD-RAM discs (4.7GB).
You can record a long program with a clearer picture
on a DVD-RAM disc.
The A–B recording function records the first half of the
program on the DVD-RAM disc and second half of the
program on the HDD. After the recording, copy the
second half recorded on the HDD to the DVD-RAM
disc. You can create a DVD-RAM library that has each
half of a program recorded at the highest possible
quality.
Notes
• For A–B recording, use a 12 cm DVD-RAM disc (4.7GB
single sided or 9.4GB double sided) that is formatted on
this unit just before recording. Do not use an 8-cm disc.
Check that the total available space of the HDD is sufficient
for the recording one DVD-RAM disc.
• DVD-R discs are not available on the A-B recording.
50
DVD-RAM
HDD
DVD-RAM
To use the A–B recording function
At step 3 ( page 42), set "Media" to "A–B". "Video"
is automatically set to "AT".
When the timer setting is completed, "
on the front panel display.
When recording starts
The same content is recorded on the HDD and the
DVD-RAM disc 10 minutes before the unit exchanges
the recording media.
Chapter marks are automatically made at the start and
end points of the overlapped recording portion, so you
can delete the unnecessary overlapped portion
afterwards.
If no DVD-RAM disc is loaded, or the loaded disc
contains recorded content, all of the recording is made
entirely on the HDD. The recording will contain one
title with a chapter mark at a dividing point.
During A–B recording, the picture quality mode is set
to "AT" and the unit automatically calculates the
picture rate from the disc capacity. Even if the picture
rate is set to "AT", the picture quality of the A–B
recording is lower than that of the recording on the
HDD, because the unit adds 10 minutes of the
overlapped portion to the recording time for capacity
calculation. Therefore, the picture rate will remain
when the unit cannot record onto a DVD-RAM disc
and records on the HDD instead.
After recording
Copy the second half of the program recorded on the
HDD to the alternate side of the double sided DVD-
RAM disc, or another single sided DVD-RAM disc. See
page 106 for dubbing operations. When you want
to delete the overlapped portion, perform the
procedure detailed on page 52 to delete the
overlapped portion either on the HDD or the DVD-
RAM disc.
If the entire program has been recorded on the HDD,
copy both parts of program onto both sides of a blank
double sided DVD-RAM disc or two single sided DVD-
RAM discs by referring to the chapter mark at the
dividing point.
" illuminates