Log Placement - Monessen Hearth DEB20 Installation And Operating Instructions Manual

LOG PLACEMENT

The positioning of the logs are critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are not
properly and firmly positioned in the appliance. Never add additional logs or
embellishments such as pine cones, vermiculite or rock wool to the heater.
Only use the logs and EB-RW (rock wool) supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use
only parts specifically approved for this heater may result in property damage
or personal injury.
Before you begin — This unit is supplied with four or five ceramic fiber logs. Do not handle these logs with your
bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash
your hands gently with soap and water to remove any traces of fibers.
PLACE LOGS ON GRATE
Figures 25 and 26
NOTE: Model DEB20 has 4 logs and models
DEB24 and DEB30 have 5 logs.
1. Install back log (#1) on two pins located near the
back of base. Check log position and stability.
. Install right center log (#) on pins located near
right front of base and center of base.
NOTE: The #2 log is a heat shield for the control
valve. It is critical that this log is sitting in its pin
placement and completely down with the front
noise of the embers placed below the front burner.
If the #2 log is not placed properly it could cause
damage to the control valve and wiring.
3. Install left center log (#3) on pin located near left
front of base and on top of right center log (#).
4. Install middle front log (#4) in front of center log.
Make sure bottom of log is resting on the center of
grate. Do not let log #4 contact the front burner.
5. DEB 24 and DEB 30 only: Rest right end of left
front log (#5) on log #3 and the top of left front log
on log #1.
6. Place back end of top center log (#5) on recessed
area of back log (#1). Cross log #6 over log # and
rest right extension on grate. Log #6 should fit on
pin on center log #3.
44D0060
Log #4
Log #1
Left
Front
Pin
Figure 25 -
Place Logs on
Grate (DEB20)
Right Front and
Center Pins
DEB Unvented Gas Logs
Log #6
LG1024
DEB20 logs
Log #1
Log #
LG104
19