Electrical Wiring - Millivolt; Connect Wall Switch Or Thermostat - Monessen Hearth DEB20 Installation And Operating Instructions Manual

ELECTRICAL WIRING - MILLIVOLT

Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Wall
Switch
On/Off Switch
Figure 18 -
Wiring Diagram
The millivolt valve is a self-powered combination gas control
THAT DOES NOT REQUIRE 110 VAC TO OPERATE.
CONNECT OPTIONAL WALL SWITCH OR
THERMOSTAT
1. Use 18 awg, two-wire cable, 15 feet maximum length.
. At one end of the cable, connect both wires to the wall
switch or thermostat. At the other end, connect one
wire to TP/TH and one wire to TH, or connect the wall
switch/thermostat to the two male (0.5") terminals on
the left side of the unit. The color of the wires does not
matter.
44D0060
TH = 3
TP = 1
TP/TH = 
Switch
On/Off
Switch
ODS Pilot
Millivolt
Valve
Spade Terminal
Optional Wall
Switch, Remote
Receiver or
Optional T-Stat
FP2112
wiring diagram
12/08
DEB Unvented Gas Logs
ODS Pilot
FP11
15