Operation - DeWalt DC411 Instruction Manual

2. Push the guard down until the guard lugs engage and rotate
freely in the groove on the gear case hub.
3. With the guard latch open, rotate the
guard (I) into the desired working posi-
tion. The guard body should be posi-
tioned between the spindle and the
operator to provide maximum operator
protection.
4. Close the guard latch to secure the guard on the gear case. You
should not be able to rotate the guard by hand when the latch
is closed. Do not operate the grinder with a loose guard or the
clamp lever in open position.
5. To remove the guard, open the guard latch, rotate the guard so
that the arrows are aligned and pull up on the guard.
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw (N) with clamp lever in the closed
position with guard installed on the tool.
CAUTION: Do not tighten the adjusting
screw with the clamp lever in the open
position. Undetectable damage to the guard or the mounting hub
may result.
CAUTION: If the guard cannot be tightened by the adjusting
clamp, do not use the tool. To reduce the risk of personal injury,
take the tool and guard to a service center to repair or replace the
guard.
NOTE: Edge grinding and cutting can be performed with
Type 27 wheels designed and specified for this purpose; 1/4"
(635 mm) thick wheels are designed for surface grinding while 1/8"
(3.17 mm) wheels are designed for edge grinding. Cutting can also
be performed by using a Type 1 wheel and a Type 1 guard.

OPERATION

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
Installing and Removing the Battery
I
Pack (Fig. 2, 3)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack into the tool handle, align the notch
inside the tool's handle with the battery pack and slide the battery
N
pack firmly into the handle until you hear the lock snap into place.
To remove the battery pack from the tool, press the release
buttons (O) and firmly pull the battery pack out of the tool handle.
Insert it into the charger as described in the charger section of this
manual.
Switch (Fig. 3)
LOCK-OFF BUTTON AND TRIGGER SWITCH
Your cut-off tool is equipped with a lock-off button (B).
To lock the trigger switch, press the lock-off button as shown in
Figure 3. When the lock-off button is depressed to the lock icon, the
unit is locked.
16
O