Keyboard Stand Assembly - Yamaha YPP-200 Ligh Piano Owner's Manual

1
46
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
YPP-200
Assembly Parts
1 6 x 70 mm round head screws (4 pcs.)
2 Joint connectors (4 pcs.)
3 3.5 x 16 mm tapping screws (12 pcs.)
2 Joint connectors
1 6 x 70 mm round head screws
Back board

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts
in the correct direction. Please assemble in accordance with
the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above.
Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of
each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
The parts shown in the "Assembly Parts"
illustration will be used. Follow the assembly
instructions and select the parts as needed.
Z
Attach the stand bases.
Making sure that the boards are facing the proper
direction (the holes should face inside), insert the joint
connectors 2 into the holes as shown. The joint
connectors have been installed properly if you can see a
plus mark on the connector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws 1.
Side boards
Stand bases
4 6 x 30 mm round head screws (4 pcs.)
5 5 x 16 mm round head screws (4 pcs.)
6 Angle brackets (4 pcs.)