Table of Contents
Advertisement
1. Transmitter Antenna: Straighten up the antenna before operating the model.
2. Power Indicator: The LED light indicates power is "on" or "off".
3. Edit Buttons: The left and right buttons are the "functions" selecting keys. The up(+) and down(-) buttons are the value adjusting keys.
For additional details on specific operation, please refer to the "function" setting procedure (Page 8)
4. LCD Display: The Cougar transmitter features an "Easy-to-Read" screen. Use the "Edit Buttons" to select the function (left and right key)
and change settings (with the "up" & "down" keys). For additional details on specific operation, please refer to the "Function" setting procedure
(Page 8).
5. Digital Steering Trim lever: Push this lever left or right to adjust the center point of the steering servo. The cursor will move on the top
ruler line of the LCD screen to display the current position.
6. Digital Throttle Trim lever: Push this lever up or down to adjust the center point of the throttle/brake servo. The cursor will move on the
left ruler line of the LCD screen to display the current position. This adjustment sets the braking amount of "Drag Brake" and "Coast Brake".
NOTE ! The Digital Throttle Trim function adjusts neutral point without affecting maximum throttle servo travel and full-throttle
position.
The Digital Steering Trim function adjusts maximum steering servo travel for both left and right steering. If adjustments are
incorrect, steering linkage binding or damages to the steering servo may occur.
7. Digital Steering D/R(Dual Rate) lever: Push this lever left or right to adjust the amount of the steering dual rate. Right to increase dual
rate amount and left to decrease the amount.
8. AUX Ch Button: Provides an extra function for the control of the model.
9. External Charging Jack: For rechargeable NiCd/NiHM battery pack on the transmitter only.
10. 24GHz binding SW: The Binding SW button is located on the back of the 2.4GHz transmitter unit. For additional details, please refer to the
"Binding" setting procedure (Page 7).
11. Steering Wheel: Controls the steering of the model.
12. Power Switch: Slide to turn the transmitter on or off.
13. Throttle Trigger: Pull or push to control throttle on the model.
14. Steering Tension Adjustment: Use a Phillip type screw driver to tighten or loosen the tension on the steering wheel.
15. Battery Cover: Slide for removing the cover and install / remove the batteries.
1.
2.
LED
3.
4.
5.
6.
7.
8.
9.
10. 2.4GHz
7
11.
12.
13.
14.
15.
LCD
2.4GHz BINDING SW
LCD
ST
LCD
10
10
Advertisement
Table of Contents
