Xerox DocuPrint N2125 Service Manual page 24

General Info Control Panel Message
Tray 3 Feed Jam Tray 3 Jam -
Open Tray 3
Envelope Feed Jam Envelope Feeder Jam/
Remove all Envelopes
MBF Feed Jam MBF Jam -
Remove All Paper
Envelope Feed Jam Envelope Feeder Jam/
Remove all Envelopes
MBF Misfeed MBF Jam -
Remove All Paper
Tray 1 Misfeed Tray 1 Jam -
Open Tray 1
Tray 2 Misfeed with Tray 2 Jam -
550 Sheet Feeder Open Tray 2
installed as Tray 2
Tray 3 Misfeed with Tray 3 Jam -
550 Sheet Feeder Open Tray 3
installed as Tray 3
Paper Jam -
Open Front Cover
Paper Jam -
Open Front Cover
Exit Jam -
Open Rear Cover
Exit Jam 1 Exit Jam -
Open Rear Cover
Status Indicator Repair Analysis Procedures
Error Code Tables
Table 1 Error Code Table
Fault History Entry Diagnostic Message
E2-03 E2-0: Feed Jam
E2-0E E2-0: Feed Jam
E2-0M E2-0: Feed Jam
E2-1E E2-1: Feed Jam
E2-1M E2-1: Feed Jam
E2-11 E2-1: Feed Jam
E2-12 E2-1: Feed Jam
E2-13 E2-1: Feed Jam
E3-1 E3-1: Reg. Jam
E3-2 E3-2: Reg. Jam
E4-0 E4-0: Exit Jam
E4-2 E4-2: Exit Jam
02/2000
2-6
Error Description Action
Paper arrives at Registration Sensor Open Tray 3
too early. Open Front Cover
Clear Paper Path
Go to
Paper arrives at Registration Sensor Remove Envelope Feeder
too early. Open Front Cover
Clear Paper Path
Go to
Paper arrives at Registration Sensor Open Front Cover
too early. Clear Paper Path
Go to
Paper does not arrive at Registration Remove Envelope Feeder
Sensor position within a specified Open Front Cover
time. Clear Paper Path
Go to
Paper does not arrive at Registration Open Front Cover or Feeder
Sensor position within a specified Clear Paper Path
time. Close the Cover
Go to
Paper does not arrive at Registration Open Tray 1
Sensor position within a specified Open Front Cover
time. Clear Paper Path
Go to
Paper does not arrive at Registration Open Front Cover
Sensor position within a specified Open Tray 2
time. Clear Paper Path
Go to
Paper does not arrive at Registration Open Tray 1
Sensor position within a specified Open Front Cover
time. Clear Paper Path
Go to
Exit Sensor did not actuate within Open Front Cover
time after the Registration clutch is Remove Print Cartridge
actuated. Clear Paper Path
Go to
1. Registration Sensor did not deactu- Open Front Cover
ate within time after actuation of Reg- Remove Print Cartridge
istration sensor. Clear Paper Path
2. Registration Sensor is actuated at Go to
power on.
Paper leaves Exit Sensor early. Open Rear Cover
Clear Paper Path
Go to
1. Paper late off Exit Sensor. Open Rear Cover
2. Exit Sensor on at power up. Clear Paper Path
Go to
RAP 8.
RAP 66.
RAP 7.
RAP 66
RAP 7.
RAP 8
RAP 8
RAP 8
RAP 10
RAP 10
RAP 11
RAP 11
Initial Issue
DocuPrint N2125