Scanner Operation; Two Default Modes Of Operation - Metrologic MS1633 FocusBT Installation And User Manual

S O
CANNER PERATION

Two Default Modes of Operation

Multi-Trigger Mode, Out-of-Stand
1. The IR detects an object in the IR
activation range and automatically
turns on linear illumination.
2. Aim the scanner's line of light
over the bar code.
3. Pull the trigger to initiate scanning.
The scanner's light output will start to
flash as it attempts to scan the
bar code.
If the trigger is released the
scanner will stop trying to
scan.
4. When scanner successfully reads the
bar code it will beep once, the white
LED will flash and the decoded data
will be transmitted to the host.
Presentation, In-Stand
1. The IR detects an object in the IR activation range and the scanner's
light output automatically starts to flash as it attempts to scan the bar
code.
2. The scanner continuously attempts to scan the bar code until either it
succeeds or the bar code is removed from the scanner's field of view.
3. When scanner successfully reads the bar code it will beep once, the
white LED will flash and the decoded data will be transmitted to the
host.
* For additional configurable modes of operation, please refer to the Area
Imaging Bar Code Supplemental Configuration Guide (
*
Figure 29. Multi-Trigger Mode,
MLPN
Out-of-Stand
00-02281).
23