Toshiba e-Studio 232 Operator's Manual page 261

Error code Problem
2C6C Invalid address speci-
fied in To: field
2C6D NIC system error
2C70 SMTP service is not
available
2C71 SMTP authentication
error
2C72 POP Before SMTP
error
2C80 Failed to process
received E-mail job
2C81 Failed to process
received Fax job
2CC0 Job canceled
2CC1 Power failure occurred
Save as File
2D10, 2D12, Illegal job status
2D13, 2D20-
2D22
2D11 Not enough memory
2D14 Invalid parameter
specified
2D15, 2D65 There are too many
documents in the
folder. Failed in creat-
ing new document.
2D30 Failed to create direc-
tory
2D31, 2D33 Failed to create file
2D32 Failed to delete file
2D40 Failed to convert
image file format
2D60 Failed to copy file
Check if there is an illegal character in the Destination E-mail
address. Delete the illegal character and reset the appropriate
Destination E-mail address, then perform the job again.
Turn the power OFF and then back ON. Retry the job in error. If
the error still occurs, contact your service representative.
Ask your administrator to enable the SMTP setting.
Check if the SMTP authentication method, login name and
password are correct.
If the SSL setting is enabled, check if the setting and the port
number of SSL correspond to those of the server.
Check if the settings of POP Before SMTP and POP3 are cor-
rect.
Ask your administrator to confirm whether the Received Internet
Fax Forward is set.
Ask your administrator to confirm whether the Received Fax
Forward is set.
Job was canceled.
Make sure that the power cable is connected properly and it is
inserted securely. Resend the job.
Turn the power OFF and then back ON.
Retry sending. If the error still occurs, contact your service rep-
resentative.
Make sure there are enough memory to save the scan job.
Make sure you specify the settings correctly and try again.
Delete the data in the local shared folder in the equipment and
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Make sure that the access privilege to the storage directory is
writable and the server or local disk has a sufficient space. Then
retry the scan.
Turn the power OFF and then back ON. Retry the scan. If the
error still occurs, contact your service representative.
Turn the power OFF and then back ON. Retry the scan. If the
error still occurs, contact your service representative.
What to do
8
259