Configuring Your Road Warrior; System Tab; Changing Camera Frame Rate; Adjusting Speedometer Unit Of Measurement - Lorex Road Warrior RW2S SERIES Instruction Manual

CONFIGURING YOUR ROAD WARRIOR

Before using your Road Warrior for a long
period of time, it is recommended to configure
the Settings menu. This ensures that you
receive the best possible performance.
Click (Setup) to access the Setup menu,
then click the appropriate tabs on the top of the
window:

System Tab

Changing Camera Frame Rate

To change camera recording frame rate:
• From the Normal (Fps) drop-down menu,
select the desired frames per
second.Twenty frames per second is
considered real-time recording.
save.
You can adjust the recording frame rate for
both the Inside camera and the Outside
camera (Driver-View camera).
Adjusting speedometer Unit of
Measurement
To change the unit of measurement that Lorex
Viewer displays:
1. Select Km or MPH.
Click OK
to save
Click OK .

Looping Video Recording

To record video on a continuous loop:
• Under Storage Method, select
to save.
OK
This will continually record video until the
memory card is full. Once the memory card
is full, the Road Warrior erases the memory
card and begins recording again.
Automatically Restarting your Road
Warrior
To prevent the Road Warrior from
encountering recording errors, you can set it to
restart automatically.
to
To enable automatic restart:
1. Select Auto Reboot.
2. Select the time you want the unit to restart.
to save.
Click OK
Cigarette lighters in import vehicles
NOTE:
turn off when the car powers off. This means
the restart function will NOT work if the
vehicle is turned off. Cigarette lighters in
domestic vehicles remain on even if the
vehicle is turned off.

Disabling Audio in Recording

To disable audio recording in both channels:
• Deselect the Enable check box under the
Audio menu.
Configuring your Road Warrior
Recycle
to save.
Click OK
.
Click
15