Hilti TE 70 Operating Instructions Manual page 8

Power tool TE 80‑ATC
Dimensions (L x W x H) 555 mm x 125 mm x
312 mm
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of
the power tool's voltage and power rating.
Power tool
Rated input
Rated current input
Mains frequency
Hammer drilling speed
Single impact energy (full power)
Single impact energy (50%
power)
NOTE
Information for users as per EN 61000-3-11: Switching on causes a brief drop in voltage. Other appliances may
be negatively affected when connected to mains supplies where conditions are unfavorable. No malfunctions
are to be expected on mains supplies with an impedance of less than <0.15 ohms.
Other information about the power tool
ATC electronic cut-out
Protection class
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the times when the
tool is switched off or when it is running but not actually doing the job. This may significantly reduce the
exposure level over the total working period. Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Noise and vibration information (measured in accordance with EN 60745):
Typical A-weighted sound power level, TE 80-ATC
Typical A-weighted emission sound pressure level,
TE 80-ATC
TE 70‑ATC
524 mm x 123 mm x
294 mm
TE 80‑ATC
1,700 W
Rated voltage 100 V: 15 A
Rated voltage 110 V: 16 A
Rated voltage 120 V: 15 A
Rated voltage 220 V: 9.8 A
Rated voltage 230 V: 9.9 A
Rated voltage 240 V: 10 A
50...60 Hz
380/min
11.5 J
5 J
TE 80‑ATC/ TE 70‑ATC
Protection class II (double insulated)
110.5 dB (A)
99.5 dB (A)
TE 70
524 mm x 123 mm x
274 mm
TE 70‑ATC / TE 70
1,600 W
Rated voltage 100 V: 15 A
Rated voltage 110 V: 16 A
Rated voltage 120: 15 A
Rated voltage 220 V, Rated
current input 1,600 W: 9.6 A
Rated voltage 230 V, Rated
current input 1,600 W: 9.8 A
Rated voltage 240 V, Rated
current input 1,600 W: 9.8 A
50...60 Hz
360/min
11 J
5 J
en
21