Inserting/Replacing The Batteries - Stanley FatMaxSP5 Instruction Manual

INSERTING/REPLACING THE BATTERIES

Remove the Universal Mount if mounted. Remove the battery cover from the
battery compartment located in the bottom of the instrument itself.
Insert the batteries or replace the used batteries with new ones.
Check for correct polarity.
Do not use rechargeable batteries!
Extreme temperatures and the use of batteries with different levels of charge
can reduce the operating time of the instrument.
Always use batteries with the same power rating and from the same manu-
facturer. For disposal of the used batteries, see the section "Environmental
protection".
CALIBRATION (Fig. G)
The SP5 is a precision instrument and needs to be handled carefully. If the
SP5 is treated roughly or accidentally dropped, it may need to be re-cal-
ibrated. Check the SP5 on a regular basis, following these steps:
1. Put the SP5 on a stable, smooth surface and turn it on. Aim one of the
side beams (1) at a vertical surface that is at least 20 meters away from
the SP5. Mark the beam's location on the wall (a).
2. Turn the SP5 180° so the other side beam is now aimed at the original
spot. Mark this new spot (b). If the two spots are at the same height,
then move on to step 4.
3. If the two spots are at different heights, mark a spot half way between
the two (c). Remove the two calibration hole covers by using a screw-
driver. Insert a hex screw (1,5 mm) into the side calibration hole (X) and
turn the adjusting screw until the laser dot is on the new mark you
made (c).
4. Turn the SP5 so that the front beam (2) is pointed at the mark you made.
If the laser dot is not lined up with the mark, insert the adjusting wrench
in the front calibration hole (Y) and turn the adjusting screw until the
laser dot is on the mark you made.
6 • SP5