Toshiba RAS-M10UKV-E3 Service Manual page 101

No. Part name
4
Heat exchanger
5
Cross flow fan
6
Base bearing
Procedures
1) Remove the front panel, electrical part
and the horizontal louver following
procedure 3.
2) Remove the pipe holder at the rear side of
main unit.
3) Remove the 2 screws on the heat
exchanger at the base bearing.
4) Remove the 2 screws on the heat
exchanger at the 2 fixed plates (upper and
lower) from the back body, and then pull
out the upper side of the heat exchanger
slowly.
1) Remove the front panel, electrical part,
horizontal louver and the heat exchanger
following procedure 4.
2) Remove the 2 screws on the band motor
(L) and remove the 2 screws on the band
motor (R) and then remove the cross flow
fan.
3) Loosen the set screw of the cross flow fan
then separate the fan and the fan motor.
Notice
To assemble cross flow fan and fan motor to
the unit, please turn the fan motor unit the
center of its terminal meets the lowest point
of band motor (R) (point A).
Fix the cross flow fan with the set screw at
the position where the gap between the back
body and the right surface of the cross flow
fan is 4 mm.
1) Remove the front panel, electrical part,
horizontal louver, heat exchanger and the
cross flow fan following procedure 5.
2) Remove the 2 screws fixing the base
bearing.
3) Remove the bearing from the base
bearing. If the housing protrudes from the
base bearing, put the housing in position
and attach the bearing to the base
bearing.
– 101 –
Remarks
2 Pipe holder
3 2-Screws
4 2-Screws
2 2-Screws (R)
2 2-Screws (L)
5 mm
3 Set screws
Middle of the fan motor terminal
2 2-Screws