Installing And Connecting The Indoor Unit Drain Hose - Samsung AM18B1C09 Owner's Instructions & Installation Manual

Installing and Connecting the Indoor Unit Drain Hose

Care must be taken when installing the drain hose for the indoor unit to ensure that any
condensation water is correctly drained outside. When passing the drain hose through
the 65mm( 9 inch) hole drilled in the wall, check that none of the following situations occur.
2
16
The hose must
NOT slope
upwards.
To install the drain hose, proceed as follows.
1 If necessary, connect the 2m(6ft. 7in) extension to the drain hose.
2 If you are using the extension, insulate the inside part of the extension
drain hose with a shield.
3 Pass the drain hose under the refrigerant piping, taking care to keep the
drain hose tight.
4 Pass the drain hose through the hole in the wall, making sure that it is
sloping downwards, as shown in the illustrations above.
The hose will be fixed permanently into position once the
whole installation has been tested for gas leaks; refer to
page 47 for further details.
The end of the drain Do NOT bend the
hose must NOT be hose in different
placed in water. directions.
I
NSTALLING THE
5cm
(2inch)
less
Keep a clearance of at Do NOT place the
least 5cm(2inch) end of the drain hose
between the end of the in a hollow.
hose and the ground.
Shield
Drain hose
I U
NDOOR NIT
Ditch
Extension drain hose
37
E-