To Operate Projector Power On - InFocus LP1200 User Manual

To operate projector power ON

Numbers 1 - 9 correspond to the instruction numbers below.
2, 9
Left side
O I
1. Put the projector into standby mode by pressing the
main power switch. The POWER indicator lights up
red.
2. Turn on the equipment connected to the projector.
3. Turn the projector on by pressing the POWER but-
ton.
The light source lamp starts warming up, eventu-
ally turning on. In cases where light source lamp
does not come on, wait for one minute before switch-
ing power on again.
• If power to the main unit is turned off within
two minutes of turning off the light source
lamp, power will not be introduced to the lamp
for one minute the next time the main unit
power switch is turned on. When this happens,
the indicator lamp will blink for one minute.
condition
stand-by
when light source lamp is on
when light source lamp does not light up
16
LAMP TEMP
RGB VIDEO CARD
3, 7, 8 4 4
indicator
LAMP POWER
-
red
green
green
- red
CARD 1 CARD 2
FINE
MENU
6
Important:
• A darkened image may be seen right after pressing
the POWER button due to warming up of this pro-
jector. When warming up, no other commands can
be accepted.
• When the lamp indicator is blinking red, the ser-
vice life of the lamp is about to end. Replace the
lamp. See pages 40 and 44.
• The picture might not be of optimum performance
in extreme hot or cold conditions. (The projector is
not malfunctioning.)
4. Select the desired external input source by using
the RGB or VIDEO button.
• The projector automatically selects the appropriate
signal system. The selected signal system is dis-
played on the SIGNAL menu.
• When selecting the RGB1 or RGB2 input, the im-
age may be flickered. Press the FINE buttons to
adjust the image.
• Press CARD button to see the PC CARD images.
(You cannot select it when CARD 1 or CARD 2 indi-
cator is not lighting up.)
AUTO
FOCUS
/ZOOM POSITION
ENTER
5
AUTO position
button