Robertshaw 9555 User Manual page 4

110-975D En.qxd
4. Remove the cover using a coin or screwdriver (Figure 3). Set aside.
5. Place thermostat against the wall at desired location. Make sure wires
will feed through opening (Figure 4) on base of thermostat.
6. Mark placement of mounting holes (Figure 4). Set base aside.
7. If mounting on drywall, tap plastic anchors into wall.
NOTE: ENCLOSED PLASTIC ANCHORS DO NOT REQUIRE A
8. Drill the marked holes using a 3/16" drill bit if mounting on a sur-
face other than drywall.
9. Align base with plastic anchors and feed wires through opening.
10. Secure base to wall with supplied screws.
NOTE: THE THERMOSTAT WILL MOUNT HORIZONTALLY
11. Strip end of wires 5/16" if needed.
5/13/03 2:43 PM
Figure 3
Mounting Holes
NON
Figure 4
DRILLED HOLE FOR DRYWALL.
ON A SINGLE GANG JUNCTION BOX.
4
Page 4
WIRING
OPENING
HP
(Black plate)