Exhaust System - Shindaiwa EB212 Owner's/Operator's Manual

Cleaning Cylinder Fins
Cleaning Cylinder Fins
1. Remove spark plug lead and spark plug.
1. Remove spark plug lead and spark plug.
2. Remove engine cover, pull cover away from engine. Loosely
install spark plug to prevent dirt from entering cylinder. Clean
cylinder fins to allow cooling air to pass freely.
2. Remove two upper 3 mm hex screws at recoil starter.
3. Remove spark plug and loosely reassemble engine cover.
Remove engine cover (five screws), pull cover away from engine.
3.
Loosely install spark plug to prevent dirt from entering cylinder. Clean
4. Tighten all screws securely.
cylinder fins to allow cooling air to pass freely.
5. Install spark plug and spark plug lead.
Remove spark plug and loosely reassemble engine cover with five cross
4.
head and two hex head screws.
5. Tighten all screws securely.

exhaust system

6. Install spark plug and spark plug lead.
Spark Arrestor Screen
Level 2.
e
Xhaust system
Parts Required: Spark arrestor screen, Gasket
Spark Arrestor Screen
Level 2.
IMPORTANT
Carbon deposits in muffler will cause a drop in engine output and
Tools required: Cross Head Screwdriver, 3 mm Hex Wrench, Soft
overheating. Spark arrestor screen must be checked periodically.
metal brush
1. Remove spark lead and spark plug.
Parts Required: Spark arrestor screen, Gasket
2. Remove engine cover.
IMPORTANT
Carbon deposits in muffler will cause a drop in engine output and
3. Remove spark arrestor covers (A, B), gasket (C) and spark ar-
overheating. Spark arrestor screen must be checked periodically.
restor screen (D) from muffler. Replace screen if plugged with
carbon deposits.
1. Remove spark lead and spark plug.
NOTE
2. Remove two upper 3 mm hex screws at recoil starter.
When cleaning carbon deposit, be careful not to damage the cata-
lytic element inside muffler.
Remove five engine cover screws and remove cover from engine.
3.
4. Install spark arrestor screen, gasket, and covers.
4. Remove spark arrestor covers (A, B), gasket (C) and spark arrestor screen
5. Loosely reassemble engine cover with five cross head and two
(D) from muffler. Replace screen if plugged with carbon deposits.
hex head screws.
NOTE
6. Tighten all screws securely.
When cleaning carbon deposit, be careful not to damage the catalytic
element inside muffler.
7. Install spark plug and spark plug lead.
5. Install spark arrestor screen, gasket, and covers.
Loosely reassemble engine cover with five cross head and two hex head
6.
screws.
7. Tighten all screws securely.
8. Install spark plug and spark plug lead.
P B
ower lower
o ' M
Perator s
d
D
17
anual
A
b
C
A
B
C