GE Profile UPSE810 Use And Installation Manual page 19

ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect it
to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 18.
CAUTION: Internal duct joints must be secured with
tape, otherwise they may separate and
cause a safety hazard.
ADDING COVER PLATE TO REAR OF CABINET
PLATE
(KIT WE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate
(Kit WE1M454) available from your local service provider.
Place dryer in final location.
WARNING - NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
For Questions on Installation, Call: 1-800-361-3400
500A280P019
CHANGING DIRECTION OF DOOR
24
OPENING
REMOVE 4
HINGE SCREWS.
ROTATE DOOR 180
AND REINSTALL.
(Kit WE1M454)
SERVICING
25
WARNING - LABEL ALL WIRES PRIOR TO
DISCONNECTION WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION
AFTER SERVICING/INSTALLATION.
For replacement parts and other information, refer to Owner's
Manual for servicing phone numbers.
Pub # 31-16077
19
REMOVE 4 HOLE PLUGS AND
PLACE THEM IN THE HOLES
ON THE OPPOSITE SIDE.
0