Installing The Sound Bar On A Wall - Sony HT-CT60BT Owner's Manual

Removing the stands
When the Sound Bar is to be placed
facing upward slightly or on a wall,
remove the two stands at the bottom
of the Sound Bar, as shown below.
Note

When the Sound Bar is placed facing
upward slightly with the stands
removed, take care not to block the
ventilation holes with carpet, etc.
Installing the Sound Bar on
a wall
You can install the Sound Bar on the
wall.
Notes

Use screws that are suitable for the
wall material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall beam.
Install the Sound Bar on a vertical and
flat reinforced area of the wall.

Be sure to subcontract the installation
to Sony dealers or licensed contractors
and pay special attention to safety
during the installation.

Sony is not responsible for accidents or
damage caused by improper
installation, insufficient wall strength,
14
GB
Stand
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied)
that are suitable for the holes on
the back of the Sound Bar.
more than 25 mm
Hole on the back of the Sound
Bar
2
Fasten the screws to the wall.
The screws should protrude 7 to
8 mm.
7 to 8 mm
4 mm
5 mm
10 mm
380 mm