Figure 21. Installing New Batteries
Replacing the Fuse
A power line surge or spike can blow the power supply fuse, causing
the LitePro to stop working. If this happens, you'll need to replace the
fuse.
The correct fuse depends on the power line voltage in the country
where you are operating the LitePro.
•
•
Follow these steps to replace the fuse.
1. Make sure that the condition that caused the fuse to blow no
2. Turn off the LitePro by pressing the " " side of the power switch
3. Unplug the power cord from the LitePro.
LitePro 560/570 User's Guide
+
-
-
+
Use only the specified power supply fuse. Using a different
fuse may damage the LitePro.
If your line voltage is 220V to 240V (as in most European
countries), use a 6.3 amp, 250V, 5x20 mm fuse.
If your line voltage is 100V to 120V (as in Japan, the United States
and most North American countries), use a 10 amp, 250V, 3AB
fuse.
A surge-protected power strip is recommended if power
surges are common in your area.
longer exists.
on the side of the LitePro.
Maintenance
43