Moving And Handling Instructions; Long Term Storage; Battery - North Star M157294F Installation, Operation And Maintenance Manual

3000 psi hot water pressure washer

Hide thumbs

Table Of Contents

Table of Contents

Maneuvering Your Pressure Washer

1.) Use the handles to move the pressure washer.

2.) To turn, lift slightly on the handles and pivot the

pressure washer on its front wheels.

3.) To engage brakes, pull brake arms out, rotate

them down and use them as chocks.

Lifting Your Pressure Washer

1.) To reduce risk of injury, it is recommended to use a

hoist to lift this pressure washer.

2.) Lift from lifting points.

During cold weather, store the pressure washer indoors and move it outdoors before starting the engine.

Follow these instructions to prevent the pump from freezing during storage.

Storage:

Before you store the pressure washer, make sure you

do the following:

1.) If adding stabilizer, run pressure washer with high

pressure hose for five minutes.

2.) Disconnect the battery and store it indoors.

3.) Disconnect high pressure and garden hose.

Winter Storage:

Items needed: 12" piece of garden hose or equivalent,

funnel and RV antifreeze (approximately 6 oz.)

1.) Follow the storage instructions listed above.

2.) Disconnect spark plug cable. Make sure the engine

start switch is OFF, and the fuel valve is OFF.

3.) Attach the garden hose with funnel to the pump inlet

(see illustration).

4.) Pour RV antifreeze into the funnel, then turn the

engine over until antifreeze comes out the pump outlet.

5.) Drain all water from the high pressure hose. Depress

trigger on gun and drain all water out of gun/lance.