FujiFilm DL-320 ZOOM Owner's Manual page 35

2. Set the interval timer
After selecting the interval, remove your finger from the Button. The display of the
interval (sec./min.) will turn off and the Interval Timer Sign
glow. The camera is now set to the interval timer mode.
3. The shutter will trip automatically at the set interval
If you press down the Shutter Release, the timer will start after the shutter is re-
leased. The sec./min. display in the LCD will count down the time before the next
shot, and when "1" (sec.) turns off, the shutter will trip automatically at the set inter-
val. Pictures are taken by repeating this operation.
•
Mount the camera on a tripod.
•
The Interval Timer Sign
•
To switch off the interval timer mode in mid-roll, press in the Shooting Mode Button.
•
The interval timer mode will automatically switch off when the last frame is exposed.
•
Zooming is not possible while the interval timer is operating.
•
The Power Switch/Exposure Mode/Landscape Mode Dial can also be operated while the inter-
val timer is operating. The picture is taken in the mode that is set when the shutter trips.
•
If the shooting interval is set to 1 minute or longer, the Lens will automatically move back into
the body after the shutter is released.
•
If the interval timer mode is switched off, the zooming position of the Lens will return to that
which was set when the interval timer mode was set.
•
If there is no film in the camera, the interval timer mode will be automatically switched off after
the shutter has tripped ten times.
will blink while the interval timer is operating.
will stop blinking and
35