Dodge RAM 2010 User Manual page 57

WHAT TO DO IN EMERGENCIES
Preparations For Jacking
• Park on a firm, level surface. Avoid ice or slippery areas.
• Set the parking brake and shift the automatic transmission into PARK, or a manual
transmission into REVERSE. On Four-Wheel Drive vehicles, shift the transfer case to
the 4L position.
• Turn the ignition to LOCK and turn on the Hazard Warning flasher.
Hub Caps/Wheel Covers — If Equipped
• The hub caps must be removed before raising the vehicle off the ground.
• For 2500/3500 single rear-wheel (SRW) models, use the blade on the end of the lug
wrench to pry the hub cap off. Insert the blade end into the pry-off notch and carefully
pop off the hub cap with a back-and-forth motion.
• On 3500 models with dual rear wheels (DRW), position the hook on the jack handle
driver into the notch on the hub cap and pull out on the ratchet firmly. The hub cap
should pop off. The wheel skins can now be removed. For the front hub cap on 3500
models, use the blade on the end of the lug wrench to pry the caps off. The wheel
skins can now be removed by using the flat end of the lug wrench to pry them off.
Insert the flat tip completely and using a back-and-forth motion, loosen the wheel
skin.
NOTE: Passengers should not remain in the vehicle when the vehicle is being jacked.
• Block both the front and rear of the wheel
diagonally opposite of the jacking position.
For example, if changing the right front tire,
block the left rear wheel.
55