Dodge RAM 2010 User Manual page 13

Installing The Top Tether Strap (With Either Lower Anchors Or Vehicle Seat
®
Belt) - Quad Cab
• Obtain tether straps by raising the head restraints and reaching between the rear
glass and rear seat. The tether strap may be retained with an elastic band.
Accessibility to the tether strap is greatly improved by raising the seat cushion to the
"up" position. Remove the elastic before use.
• Place a child restraint on each outboard rear seat and adjust the tether strap so that it
will reach under the head restraint to the tether anchor directly behind the seat and
then to the anchor directly behind the center rear seat.
• Pass each tether strap hook under the head restraint and through the loop of webbing
behind the child seat.
• Route each tether strap to the anchor behind the center seat, and attach the hooks to
the metal ring.
• Place a child restraint on the center rear seat and adjust the tether strap so that it will
reach under the head restraint to the tether anchor directly behind the seat and to the
anchor directly behind the right seat.
• Install the child restraint and remove the slack in the tether strap according to the
manufacturer's instructions.
• Improper installation of a child restraint to the LATCH anchorages can lead to failure
of an infant or child restraint. The child could be badly injured or killed. Follow the
manufacturer's directions exactly when installing an infant or child restraint.
• An incorrectly anchored tether strap could lead to increased head motion and
possible injury to the child. Use only the anchor positions directly behind the child
seat to secure a child restraint top tether strap.
Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first, pull enough of the seat belt webbing from the retractor
to route it through the belt path of the child restraint and slide the latch plate into the
buckle.
• Next, extract all the seat belt webbing out of the retractor and then allow the belt to
retract into the retractor. Finally, pull on any excess webbing to tighten the lap portion
around the child restraint. Any seat belt system will loosen with time, so check the
belt occasionally, and pull it tight if necessary.
/Crew Cab - Rear Seats:
WARNING!
GETTING STARTED
1. Inner Anchor Strap Ring(s)
2. Snap Hook
3. Tether Strap
4. Passenger's Side Rear Child Seat
5. Rear Center Child Seat
6. Driver's Side Rear Child Seat
11