Alpine CVA-1014 Owner's Manual page 53

To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Foot Brake Lead/Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
1
Vehicle Cable
FOOT BRAKE
(Yellow/Black)
CVA-1014
PARKING BRAKE
(Yellow/Blue)
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
CVA-1014
NOTES
• If your vehicle has no ACC power supply, add an
SPST (Single-Pole, Single-Throw) switch (sold
separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are
in the case when CVA-1014 is used individually.
• If the switched power (ignition) lead of the CVA-1014
is connected directly to the positive (+) post of the
vehicle's battery, the CVA-1014 draws some current
(several hundred milliamperes) even when its switch is
placed in the OFF position and the battery may be
discharged.
Installation and Connections
Pinch Connector
Monitor Cable
Stopper
Foot brake lead
Pinch Connector
Pinch Connector
Parking brake lead
IGNITION
(Red)
BATTERY
(Yellow)
2
Foot brake lamp
Foot brake switch
Parking brake lamp
Parking brake switch
SPST SW (Optional)
Pliers
Chassis
Battery
FUSE (5A)
(optional)
FUSE (10A) (optional)
Battery
51
-EN