The Replacement Of Tail Lamp; The Replacement Of Fuse; The Way Of Lubricating - Generic Trigger X User Manual

The replacement of tail lamp

Caution:
The cathode wire should be reassembled on the frame
Use the screwdriver to driver the screw off, then open the tail lamp cover, replaces a new same standard
bulb on
Attention:
When replacing the bulb, must need the same standard as the original, the higher power bulb will increase
the possibility of battery decrease.

The replacement of fuse

The fuse is located beside the battery, if the fuse does always break, that means that the electric cycle is
inshort circuit or overload. Please contact us soon in order to mend in time.
Alarm:
Do not use other fuse out of standard, that may cause serious
negative effect even will burn lamp, cause fire, or causing losing
engine power, it is very dangerous.

The way of lubricating

Proper lubricate can maintain the excellent work of every part of
motorbike, also can extend the time of using, increase the safety
of driving. After long time driving, raining or water cleaning, we
suggest you to do a lubricate. The details are below:
,Ｙ Motorbike lubricant
,Ｚ Fat lubricant
1. clutch handle shaft ,Ｚ
2. side stand connect bolt and string clasp ,Ｚ
3. shift bar shaft ,Ｚ
4. front break handle shaft ,Ｚ
5. throttle pulling cable ,Ｙ
6. rear break kit shaft ,Ｚ