Setup Password - Acer Power 4100 User Manual

Setting a Password
1. Make sure that switch 2 of S1 is set to
2. Enter the BIOS utility and select System Security.
3. Highlight the Setup Password parameter and press
appears:
Enter your new Password twice.
may be up to 7 characters long.
Enter Password .................. [XXXXXXX]
Enter Password again ............ [XXXXXXX]
Set or Change Password
4. Type a password. The password may consist of up to seven characters. Then press
.
You cannot enter the BIOS utility if a Setup
password does not exist and switch 2 of S1 is set
to Off (password check enabled).
By default, switch 2 of S1 is set to
password).

Setup Password

(bypass password).
On
Password
On (bypass
or . The following screen
Chapter 3 - BIOS Utility 3-29