Upgrading The Cpu; Removing The Pentium Ii Cpu; Pressing The Latches - Acer Power 4100 User Manual

4.7

Upgrading the CPU

The board supports the Pentium II processors with speeds ranging from 233 MHz to 450
MHz. It utilizes the new enclosed packaging technology called S.E.C (single-edge contact)
cartridge, that allows the second-level cache to remain tightly coupled to the processor. It is
capable of increasing the performance of 32-bit software and multimedia applications.
4.7.1

Removing the Pentium II CPU

Before you can replace or upgrade your processor, you need to remove the previously installed
processor on the system board.
Follow these steps to remove the Pentium II CPU:
1. Disconnect the 3-pin and 2-pin fan/sink cables from the system board.
2. Press the latches on both sides of the processor to release it from the retention
mechanism. You will hear a click sound once the latch is released.
Figure 4-16 Pressing the Latches
3. Pull the processor to totally detach it from the CPU connector.
4-18 AcerPower 4100 User's Guide
Observe the ESD precautions when installing or
removing a system component. See section 4.1.1.