Power-On Password - Acer Power 6100 User Manual

2. Open the system housing and set switch 5 of SW1 to On to bypass the password function.
3. Turn on the system and enter the BIOS utility. This time, the system does not require you to type in a
password.
You can either change the existing Setup
password or remove it by selecting None. Refer
to the previous section for the procedure.
3.9.2

Power-on Password

The Power-on Password secures your system against unauthorized use. Once you set this password, you have to
type it whenever you boot the system. To set this password, enter the BIOS utility, select System Security, then
highlight the Power-on Password parameter. Follow the same procedure as in setting the Setup password.
Make sure switch 5 of SW1 is set to Off to enable
the Power-on password.
Index
lxxxiii