Acer Power 6100 User Manual page 65

The following screen appears if you select any of the IDE Drive parameters:
IDE Primary/Secondary
Channel Master/Slave
Type ...........................[ Auto ]
Cylinder .....................[ ---- ]
Head .........................[ ---- ]
Sector .......................[ ---- ]
Size .........................[ XXXX ] MB
Hard Disk Size > 504MB .........[ Auto ]
*Hard Disk Block Mode ...........[ Auto ]
*Advanced PIO Mode ..............[ Auto ]
*Hard Disk 32 Bit Access ........[Enabled]
*DMA Transfer Mode ..............[ Auto ]
*CD-ROM Drive DMA Mode ..........[Enabled]
↑↓ = Move Highlight Bar
Esc = Exit
Type
This parameter lets you specify the type of hard disk installed in your system. If you want BIOS to automatically
configure your hard disk, select Auto. If you know your hard disk type, you can enter the setting manually. The
default setting is Auto.
Setting this parameter also sets the Cylinder, Head, Sector, and Size parameters.
Cylinders
This parameter specifies your hard disk's number of cylinders, and is automatically set depending on your Type
parameter setting.
F1 = Help
→ ← = Change Setting,
Index
lxv