Maintenance - Stamina 40-0100B Owner's Manual

OPERATIONAL INSTRUCTIONS
USING THE ELECTRONIC TIMER
TIMER Function: The electronic timer displays minutes and
seconds up to 99.59.
1. To time your workout, begin by pressing and holding the
button on the face of the timer until zeros are displayed.
Release the button.
2. Start the timer by pressing and releasing the button. Now you
are ready to begin your workout.
3. To stop or pause the timer, press and release the timer button.
This freezes the workout time. To resume your workout without
losing the time displayed before stopping or pausing, press
and release the button again.
4. When you complete your workout, press and release the timer
button. The timer will automatically turn off after being in stop
or pause mode for 4 minutes.
NOTE: Even after the timer automatically turns off, the time that was displayed prior to shut off will
remain in memory. To resume your workout without losing the time displayed before stopping,
press and release the timer button. To clear the time and start a new workout, press the timer
button and hold it down for two seconds.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the timer.
2. The timer operates with one AAA battery, one battery included.
Refer to the illustration to install or replace the battery.
NOTE: Rechargeable batteries are not recommended.

MAINTENANCE

The safety and integrity designed into the inStride® Foldaway Step'n Tone can only be maintained
when the inStride® Foldaway Step'n Tone is regularly examined for damage and wear. Special
attention should be given to the following:
1. Inspect the RESISTANCE BANDS(33, 34) and RESISTANCE HAND STRAPS(19) for nicks and cuts.
Replace damaged RESISTANCE BANDS(33, 34) and RESISTANCE HAND STRAPS(19).
2. Verify that the WARNING LABEL(27) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(27) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the inStride® Foldaway Step'n
Tone removed from service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the inStride®
Foldaway Step'n Tone.
6. Keep your inStride® Foldaway Step'n Tone clean by wiping it off with an absorbent cloth after use.
8
AAA Battery