Engine Oil; Change Engine Oil And Oil Filter - Victory V92TC Owner's Manual

Maintenance

Engine Oil

Change Engine Oil and Oil Filter

This procedure involves using a small automotive style oil
filter wrench.
1. Start and run the engine until it reaches normal
operating temperature. Stop the engine.
2. Securely support the motorcycle on the sidestand.
3. Place an oil drain pan under the drain plug and oil filter
(center rear of the engine).
4. Remove the drain plug and seal, allowing the oil to
drain into the pan.
5. Use an oil filter wrench to loosen the filter slowly.
Allow oil in the filter to drain before removing the
filter. Remove the oil filter.
6. Use a new seal and reinstall the drain plug.
Torque: 25 ft- -lbs (34 Nm)
7. Clean any residue or debris from the oil filter mounting plate and threads.
8. Make sure the new oil filter gasket is properly seated in the oil filter, and apply a thin film of clean
engine oil to the gasket. Screw the new filter on until the gasket contacts the filter mounting plate.
Tighten the filter by hand an additional 1/2 to 3/4 turn.
9. Fill the crankcase through the oil fill cap with 6 quarts (5.7 liters) of the proper grade and viscosity oil
(see "Engine Oil Specifications," page 139).
74
2
1. Oil Filter
2. Drain Plug (under engine)
1